|
The T-M199 is very similar to the T-M1
and offers the same amount of thermal efficiency but yields a lower amount
of BTU's. The T-M199 offers manifolding capabilities and works well for
both commercial and residential applications.
The T-M199 fills a niche between the T-K3
and its big brother the T-M1.
Parallel Installation:
Like the T-M1, the T-M199 can be installed in parallel with up to 20 units
per controller, for a total of 108 GPM at 60ºF ∆T, or 130 GPM at a
50ºF ∆T. This large flow capacity through parallel connections will
meet the hot water needs of all high-volume residential and commercial
applications.
Direct-Vent Conversion:
The T-M199 can be converted to a direct vent model for inside installation
that needs to import combustion air from the outside.
Four Temperature Settings:
The T-M199 offers four separate temperatures, set by dipswitch: 113ºF ,
122ºF, 140ºF, and 182ºF. Setting temperatures other than these four
presets requires the TM-RE10 temperature controller.
At 199,000 BTU/h, the T-M199 offers outputs
similar to the T-K3, but its maximum flow rate is higher at the lower
∆T range.
At a ∆T of 60ºF in warmer areas -
for example, where the winter ground water is 60ºF and with the output
set at 122ºF - the unit will provide a 5.4 GPM, or 324 GPH.
In colder areas where the input temperature
may be 40ºF or less, expect a flow rate about 4.1 GPM, or 246 GPH.
.
| Natural Gas
Input |
Min. 25,000 Btu |
Max. 199,000 Btu |
| LPG Input |
Min. 25,000 Btu |
Max. 199,000 Btu |
| Gas Connection |
3/4" NPT |
|
| Water Connection |
3/4" NPT |
|
| Natural Gas
Pressure Inlet |
Min. 5.0" WC |
Max. 10.5"WC |
| LP Gas Pressure
Inlet |
Min. 11"WC |
Max. 14"WC |
| Weight |
70 lbs |
|
| Dimensions |
23.6" x 18.5" x
8.9" |
|
| Ignition |
Electronic Ignition |
|
| Electrical
Supply |
AC 120V (60 Hz) |
|
| Water Pressure |
Min. 15 psi |
Max. 150 psi |
| Natural Manifold
Pressure |
1.8" WC |
|
| LP Manifold
Pressure |
2.3" WC |
|
Safety is top of mind
for Takagi. When thinking about product safety, consider the following:
 |
Consistently
safe temperature: All
of our units are factory set at 122°F, offering a safe
and steady temperature with computer controlled precision. |
|
Venting
: All Takagi water
heaters use the safest venting on the market today. The venting seals the exhaust from the top of the unit
through the exterior and the built-in exhaust fan ensures
any harmful fumes are fully expelled from the home every
time the water shuts down. |
|
Safety
Devices: Takagi uses
smart safety and monitoring devices to ensure that the
system is working flawlessly. Computerized electronics
allow a Takagi water heater to monitor itself, so you
won't have to. |
|
Safer
In An Earthquake: With
a Takagi, there is no pilot light to ignite flammable
vapors and no heavy tank to fall or pull pipes out of the
wall, eliminating the risk of scalding from ruptured hot
water pipes as well. |
|
|
